VISION VIXIB250TS (B250M-C/CSM) - PXE Instructions
<DEL> to enter BIOS
Boot - BOOT  Option Priority - Boot Priority #1 "UEFI LAN"
Boot - SI Configuration - PCH SATA boot only - "Disabled"
Advanced - Network Stack Configuration  - Ipv4 PXE Support " Enabled
F10 to save and exit. 
After you have completed the OS installation restore the default BIOS setting by pressing F5  and then F10 to save and exit.

LOGICAD 45525 (B360M-C/CSM and Mini) - PXE Instructions
<DEL> to enter BIOS
Peripherals/ SATA Port 0 Boot Only - Disable
Network Stack - Enable
IPV4 - Enable
Note: MAC address shows under Peripherals
Note: Change Graphics Priority, Chipset, Internal Graphics - Auto, En, Dis

LOGICAD 397E (HPW) - PXE Instructions
<DEL> to enter BIOS
ADVANCED /PCIE /PNP /NETWORK STACK ENABLE
BOOT / BOOT OPTION PRIORITY / Set UEFI LAN 1st
Note: Onboard LAN only supports pure 1gbe, additional card needed to support 100mb

MUSTANG W640SR - PXE Instructions
<DEL> to enter BIOS
ADVANCED / DEVICE CONTROL / ONBOARD LAN = ENABLE
BOOT /LAN REMOTE BOOT = ENABLE
BOOT OPTION = NETWORK
Note: If incorrect BIOS password is used, options will be read only